How to disassemble the sliding plate of the single-board double-station screen changer

Remove the two ends of the slide plate of the single-board double-station screen changer (the method is the same for the square and round single-board screen changers). Since the cylinder stroke is not enough, a 450mm long round steel is needed. After the slide plate is removed, remove the cylinder and the cylinder support rod, and use an open-end wrench.

How to disassemble the inlet side ring of the single plate double station screen changer

After the sliding plate of the single-board double-station screen changer is removed, there will be a small gap between the inlet side ring and the main body. Use a copper bar to tap up and down the gap until the ring is knocked out. Note that the ring should be knocked out evenly up and down. Note: After the slide plate and ring are removed, the material on the slide plate and ring needs to be cleaned up!

batte melt pump and screen changer manufacturer, produces and sells hydraulic screen changers suitable for: extrusion and pelletizing lines from plastic resin synthesis reactors to bulk granules, ceramic extrusion lines, polymer (plastic and rubber) molding Production lines, including blown film, cast film, sheet, pipe, profile, plastic recycling, pelletizing, wire drawing, underwater pelletizing, masterbatch pelletizing, and extrusion lamination lines. Various granulators, extruders, film blowing machines, wire drawing machines, sheet extruders, pipe extruders. Different types of screen changers are applied to meet different application and process requirements. Manual or low-speed screen changers require that the production line must have a short time to stop filtering to make changes, while high-speed screen changers and some special structure screen changers can realize screen change without stopping or when the extrusion speed is slowed down. Welcome to consult and purchase info@battemachinery.com

Previous：Matters needing attention in the daily operation of the screen changer of the polypropylene extrusio
Next：Precautions for processing rubber melt gear pump